bluedog225
Well-known member
These used to be a thing. But I don’t hear much about them anymore.
My Slinger V2 model stopped working. It’s about 8 foot or so fan with nine blades. It never worked great. It would shut off after a while on its own. And the air movement was mediocre. But still, I got the job done.
I made the mistake of running it on high speed for a couple of days. It’s been hot and I’ve been stuck at home. Looks like I burned out the control board.
Looking around, this is not uncommon. Try to get a hold of fanimation, but they’re non-responsive and the part doesn’t seem to be available anywhere.
Too bad. I hate to throw the whole thing away. Do you think there’d be a way to run this thing directly from a wall switch without all the fragile electronics,
My Slinger V2 model stopped working. It’s about 8 foot or so fan with nine blades. It never worked great. It would shut off after a while on its own. And the air movement was mediocre. But still, I got the job done.
I made the mistake of running it on high speed for a couple of days. It’s been hot and I’ve been stuck at home. Looks like I burned out the control board.
Looking around, this is not uncommon. Try to get a hold of fanimation, but they’re non-responsive and the part doesn’t seem to be available anywhere.
Too bad. I hate to throw the whole thing away. Do you think there’d be a way to run this thing directly from a wall switch without all the fragile electronics,
Last edited:
