I had vct installed in my garage about 3 months ago and I need to seal it. If I go the epoxy route I will only use wolverine. If any of you have used wolverine for your sealer, please let me know how you like it.
Fred if your out there and see this, I know you have a new material, Bondtite 1107. My question to you is whether or not I will need the EnduraShield 2254 also. I know epoxies will yellow over time if exposed to uv light. I have 2 outside doors facing west, 1 is a 3'x7' walk door and the other is a 10'x12' overhead door. Sun does not reach the doors until 6 pm (I have a large covered drive up section in front of the doors). I have 2 transluscent panels in my walls about 12' off the ground for natural light. Do you think I will have any problems with the yellowing effect. I know the EnduraShield will prevent the yellowing but it is a lot more money also.
Kenny
Fred if your out there and see this, I know you have a new material, Bondtite 1107. My question to you is whether or not I will need the EnduraShield 2254 also. I know epoxies will yellow over time if exposed to uv light. I have 2 outside doors facing west, 1 is a 3'x7' walk door and the other is a 10'x12' overhead door. Sun does not reach the doors until 6 pm (I have a large covered drive up section in front of the doors). I have 2 transluscent panels in my walls about 12' off the ground for natural light. Do you think I will have any problems with the yellowing effect. I know the EnduraShield will prevent the yellowing but it is a lot more money also.
Kenny