Finally laser marked some of my tools

[chadster1]

I have had my laser engraver for a little over two years. I can't believe its taken me this long to mark a few of my tools.

 

[Smokenarrow]

I used to have access to one, and I've thought about this. I would probably come up with an icon or something as opposed to my name or initials. It kills any resale value when a name is scribed onto hand tools. Regardless, looks good though. What engraver are you using for that?

 

[chadster1]

I used to have access to one, and I've thought about this. I would probably come up with an icon or something as opposed to my name or initials. It kills any resale value when a name is scribed onto hand tools. Regardless, looks good though. What engraver are you using for that?

Epilog Helix 60 watt.

I don't plan on marking my tools since I don't work in a shop. I just wanted to do an experiment so I could test the settings.

 

[bfm336]

With direct laser or with (and I forget the name) that stuff that you spray on and leaves a black mark behind?


Sent from my iPhone using Tapatalk

 

[mrborohachi]

I would have been lasering high vis numbers on my SO impact sockets.