To avoid these ads, REGISTER NOW!

Finishing up the siding

B

billwood437

Well-known member
Joined
Dec 4, 2015
Messages
92
Location
Massachusetts, USA
Great weekend for finishing up the siding on the never-ending project. A few pictures to update the progress.Time to start preparing for the concrete floor. The side door is going to be a sliding barn door.
c99c6aa585e281f418da9a4a0d8f4edd.jpg
1ef216993ead87682c97be8caa382678.jpg


Sent from my SPH-L710 using Tapatalk
 
To avoid these ads, REGISTER NOW!
OP
B

billwood437

Well-known member
Joined
Dec 4, 2015
Messages
92
Location
Massachusetts, USA
It is 26x40, and has a 2nd floor over the front 2/3rd's. A steel beam runs from between the doors back 25' with 1 post at the end. The back is cathedraled up to put a 2 post lift in. Next is the floor and electrical.

Sent from my SPH-L710 using Tapatalk
 
OP
B

billwood437

Well-known member
Joined
Dec 4, 2015
Messages
92
Location
Massachusetts, USA
My never ending project hits a big milestone, The Floor is Poured!!uploadfromtaptalk1468153912075.jpg
5" minimum with mesh and rebar at the 3 door openings. They finished smooth as glass. 8" thick area behind the post with a mat of bar 8" o.c. at the bottom where 2 post lift will sit.

Sent from my SPH-L710 using Tapatalk
 
To avoid these ads, REGISTER NOW!
OP
B

billwood437

Well-known member
Joined
Dec 4, 2015
Messages
92
Location
Massachusetts, USA
captain14 said:
Nice looking build. How are you adjusting the grade for the man door on the side?

How long have you been working on this?
Click to expand...
Its been about a year. I have done a lot of the work myself so it has taken longer than expected. I will have a couple of stairs out the back to a path leading to the driveway. So far the only parts I have subbed out was the foundation walls (I poured the footing), the slab and the shingles (I needed a break). I also just had the overhead doors installed.
I owe payback Labor to a few friends and family who helped with the framing. Though I would have been there for them anyway. I am going to acid stain and seal the floor. I am putting in a new 200 amp service. Fun fun fun

Sent from my SPH-L710 using Tapatalk
 
OP
B

billwood437

Well-known member
Joined
Dec 4, 2015
Messages
92
Location
Massachusetts, USA
Just finished acid stain and sealing the floor with 2 coats of sealer. Almost ready for the electrical inspection and then they can hookup the power on the pole.
1729baa347c82b5cfbc53c039627876f.jpg
3c8c1404656971ae9a6946ebefdfb618.jpg


Sent from my SM-N930P using Tapatalk
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom