Fix an epoxy job gone bad

[sjmccarthy]

2 years ago I applied armor proxy to two different floors at my home garage & barn. One floor is the 3 car garage that was laid 15 years ago and the other is my detached barn that was finished in 2016.

We followed ALL manufacturers instructions in both spaces and did not drive or move anything in until 10 days after.

Two years later we are seeing pretty substantial failure in both areas but the failures aren’t the same. In the attached garage small patches are coming completely up and in the detached barn, edges near expansion joints are flaking and some areas show large patches where it’s turned lighter as if water stained it

I’m just outside of Philadelphia and wondering if anyone has a suggestion on someone to re-do it all or even fix it

Thanks!

 

[ford33]

And when you contacted Armor Poxy they said?

This is your first post to GJ so I'll be the first to ask the question you should have answered in your post.

 

[SALIV8]

I think armor poxy is on this board. Theyll be able to help Im sure.

 

[sjmccarthy]

And when you contacted Armor Poxy they said?

This is your first post to GJ so I'll be the first to ask the question you should have answered in your post.

Gee, just asking a question. Their response was unfortunate. Basically, send a picture and you’ll have to grind it down.

Now to further expand on my question, is there someone in this area that does that work that the board would recommend?

Sorry if I offended you with my poorly posed first question. Geez.