To avoid these ads, REGISTER NOW!

Forklift parts

NebrTd

Well-known member
Joined
Feb 23, 2017
Messages
65
Location
Nebraska
I recently aquired a Toyota forklift. It had an electrical fire that melted the fuse box. I need to source some replacement parts. I have looked online for some parts, but parts for a forklift are not near as easy to find as vehicle parts.
Does anyone have a good idea where to source new or used parts for Toyota forklifts? It is a 7FGCU35.

Thanks
 
To avoid these ads, REGISTER NOW!

seanb02

Well-known member
Joined
Apr 11, 2017
Messages
720
Location
The Farm
Fuse boxes on equipment are typically nothing real special. Unless you have some reason to keep it all original I would recommend looking into universal type of replacements. What other parts are you looking for besides the fuse box? It is a new enough machine I would think you could still get parts through a dealer that sells and services Toyota equipment, if you have nobody locally it may take a phone call or two with some other larger dealer outside of your general vicinity to find someone willing to deal with shipping you the parts, but still easy enough to figure out.

I find quite frequently that replacement parts for equipment is easily available through dealers, but more often than not I can't find anything online even when searching for the exact part number. A lot of things just aren't mass produced enough or replaced often enough for a company to bother with listing online. Older equipment where you can't get things through a dealer are different as the aftermarket industry will begin to take over at that point.
 

Jmonnty

Well-known member
Joined
Dec 6, 2015
Messages
172
Location
Dowelltown TN


I get most of my parts from this company, they're competitive with internet sources, depends on who you talk to if that will remember gaskets that aren't listed in the repair kits and other small items.
You might try the local toyota forklift dealer.
I have a 7fgcu25, the smaller version
 
To avoid these ads, REGISTER NOW!
OP
N

NebrTd

Well-known member
Joined
Feb 23, 2017
Messages
65
Location
Nebraska
Thanks for the info so far. Factory direct parts are almost $4k for just a wiring harness and controller. I have some inqiries out to salvage yards now. We will see how that turns out. I wish there was a good way to bypass the computer stuff and just make it go/stop and up/down/side-to-side.
 
To avoid these ads, REGISTER NOW!
Top Bottom