savage407
Well-known member
Early '60's Model 1D Toolmaster vertical milling machine, 40 taper spindle, infinitely variable speed 85 - 3800 rpm, 10" x 42" table, 1-1/2 Hp drive motor.
Also has shaping attachment with set of original Cincinnati shaper tools. Attachment has 1/2 Hp motor, 6 speeds.
3 phase motors but set up with a variable frequency drive, runs on 240V single phase.
Well used but works great, not pretty but this is a plug-and-play machine. A few end mill divots on the table. LH lead screw support and micrometer collar were missing when I got the machine, fabricated replacements. Also missing the quill feed lever, using a 5/8" bolt as a temporary replacement.
No power feeds. I did pick up a spare power feed gearbox (for the spindle) which is included. Complete except for the drive gears.
Spindle wrench, operating, service, parts manuals included.
$1500, pick up in Woodbine, MD 21797. Weighs 2450 pounds according to the manual. I can load.
Also has shaping attachment with set of original Cincinnati shaper tools. Attachment has 1/2 Hp motor, 6 speeds.
3 phase motors but set up with a variable frequency drive, runs on 240V single phase.
Well used but works great, not pretty but this is a plug-and-play machine. A few end mill divots on the table. LH lead screw support and micrometer collar were missing when I got the machine, fabricated replacements. Also missing the quill feed lever, using a 5/8" bolt as a temporary replacement.
No power feeds. I did pick up a spare power feed gearbox (for the spindle) which is included. Complete except for the drive gears.
Spindle wrench, operating, service, parts manuals included.
$1500, pick up in Woodbine, MD 21797. Weighs 2450 pounds according to the manual. I can load.
