G-Floor / Better Technology Flooring question

[Lombie]

I posted this in the flooring section, but think it might be appropriate here, too.

I was at Costco today and they've put rolls of G-Floor on rebate so it's now $1.059/sq ft or $135/roll, so I'm seriously considering it, as epoxy isn't in the budget. It's the black diamond-tread pattern.

I've read a number of postings here that are generally positive about G-Floor, but I wondered if anyone can offer an update on how it's holding up for them? Shifting? Moisture underneath? Issues with impressions from heavy equipment?

Also, I have a step at the front of my garage that runs the width of the garage. Any suggestions on how to best install in this situation? I'm specifically concerned about the vertical portion of the step.

Thanks!

-Lombie

 

[pattenp]

I have the G-floor mats that are the gray coin pattern. They move around a bit and every spring I remove stuff sitting on them to straighten the mats out. Things like jack stands will leave permanent marks. I've got dark tire track stains. Water dripping from the cars does get under the mats at the overlaps. The mats are okay but not the perfect floor covering. You need to pull the car in without turning the tires once on the mat because the mat will bunch a bit. You can glue down the mats but I didn't. Being a soft PVC they do get stained and the stains don't come out easily with just soap and water. I've used mineral spirits at times to get stain out.

 

[Lombie]

Thanks for your feedback, pattenp.

Do you happen to know the thickness of the mats you have? 55, 75, or 85 mil?

Most of the problems I've read about seem to be with the thinner mats.

Hopefully others can chime in, too. Not sure I could create a 1 response post on GJ if I tried...

Thanks again!