To avoid these ads, REGISTER NOW!

Garage Door Insulation

rbtempe

Member
Joined
Jan 6, 2015
Messages
10
Anyone insulate their garage door? What product did you use? Any challenges with weight?

Looking to reduce heat my Arizona garage door faces South gets lots of sun and hot to the touch.

Cheers
 
To avoid these ads, REGISTER NOW!

davidlee

Well-known member
Joined
Aug 1, 2012
Messages
275
Location
Pensacola, Fl
I bought a kit form Lowes. It worked well, was easy to install but there is not enough in the kit to do a 9' wide door. I have three doors so I will have to buy a total of four kits.
It is a online purchase only but if you don't like it you can return it to the store for a refund.
 
OP
R

rbtempe

Member
Joined
Jan 6, 2015
Messages
10
Thanks for the replys.

At the big box stores I've seen the fiberglass kits "pink panther" and the foam kits. Weight wise pink fiberglass kit feels a bit heavier but not too much different than the foam kit. It will take two kits around $150 to do the job either way.
 

GN4WHLN

Well-known member
Joined
May 8, 2009
Messages
2,073
Location
Alta Loma, CA
I went with the 1 1/4 foil backed foam. Cut to size and pushed them in. About $60.00 in materials and a couple hours work. The garage is quieter and more temp stable.
 
To avoid these ads, REGISTER NOW!

prowler777

Well-known member
Joined
Jul 8, 2010
Messages
277
Location
Surprise,Az.
i used the 4x8x foam foil panels as well.i have a double door and a single door.each panel at lowes was 13-14 dollars.i think i used 5 i think.it has taken about 10 degrees out of the garage.i live in AZ as well-surprise to be exact.
 

crab

Well-known member
Joined
Jan 8, 2015
Messages
940
Dubber, you need to do the windows to, at least in the winter. It wouldn't change the looks from outside. A lot of cold air comes off those windows. And it looks nice, good job.
 

Grimly

Well-known member
Joined
Feb 5, 2014
Messages
181
Location
Ireland
My internal door were 18mm OSB, laminated with 1" polyisourocyanate (that doesn't look right) and faced on the inside with hardboard. All sections bonded with polyfoam glue and weighted down until cured. They're very effective, but draught-sealing is vital, as a current of air sneaking past on all the edges negates a lot of heat.
 
To avoid these ads, REGISTER NOW!
Top Bottom