dmaxfireman
Well-known member
Does anybody have the Generac repair manual for an XC8000E?
I have one with 9hrs on it that is over revving with no load.
I have one with 9hrs on it that is over revving with no load.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Generac
- Thread starter dmaxfireman
- Start date
OP
dmaxfireman
Well-known member
I believe I am having a problem with the idle control coil. Starts fine, then once it begins to warm up it speeds up until I have to shut it down over the course of a minute or two.
RTM
Well-known member
Looks like they are all available here.
https://www.generac.com/service-sup...roductid=332c6398-c93a-4644-9225-d96df864e6c4
https://www.generac.com/service-sup...roductid=332c6398-c93a-4644-9225-d96df864e6c4
OP
dmaxfireman
Well-known member
I found those, and the wiring schematic has been very helpful. But I'm looking for test parameters or known good test values for the components.
RTM
Well-known member
Nowadays, most of them say, Replace the Board. Will poke about more later.