Glad to be here

[versalowen]

Hello everyone, I've known about this forum for a while but only recently decided to register. My interest in tools began when I was lent a set of snap-on ratcheting spanners at work. I was very impressed with the quality and also, they were shiny! Since then I've been researching tools to aid in my line of work as a service engineer. Hope to learn from ya'll on this forum.

 

[DekNgo]

Welcome

 

[micromind]

Welcome from western Nevada.

There's a ton of knowledge here, occasionally you'll need to wade through some BS to get it though.......lol.

Seriously though, the Mods keep the site pretty clean.

 

[BSWS]

You've come to the right place. Soon you'll have a garage full of tools that you never knew that you needed. As I write this I'm looking at a recently acquired 62 year old Craftsman drill press that I never knew I would be obsessed with.

 

[nadogail]

Hello everyone, I've known about this forum for a while but only recently decided to register. My interest in tools began when I was lent a set of snap-on ratcheting spanners at work. I was very impressed with the quality and also, they were shiny! Since then I've been researching tools to aid in my line of work as a service engineer. Hope to learn from ya'll on this forWelcome

Hello everyone, I've known about this forum for a while but only recently decided to register. My interest in tools began when I was lent a set of snap-on ratcheting spanners at work. I was very impressed with the quality and also, they were shiny! Since then I've been researching tools to aid in my line of work as a service engineer. Hope to learn from ya'll on this forum.