To avoid these ads, REGISTER NOW!

Good "electrical for dummies" book

d33pt

Well-known member
Joined
Oct 26, 2008
Messages
547
Can someone recommend a book for basic household electrical work? I'm looking into running some new grounded outlets for my old (1950's) house with no grounds inside the house. I'm also looking at moving my 220v line for the air compressor underground. I'm pretty good with 12v stuff, but not so much with household electrical.
 
To avoid these ads, REGISTER NOW!
OP
D

d33pt

Well-known member
Joined
Oct 26, 2008
Messages
547
what kind of errors? are they the kind that would zap you later on?
 

MrMark

Well-known member
Joined
Jan 25, 2010
Messages
4,626
Location
Southern Cal.
The errors were obvious for the most part. Mainly with the picture schematics of circuits. For example, showing two romex, hooked to a recepticle at the end of a run. Like I said though, the errors were in the prior book. There's some stupid stuff in there too, like guys tightening recepticle screws with Dewalt drills, but you can only laugh at that.

This revised edition should be thoroughly vetted. The Taunton "Complete" series books seem to be good.
 

kbs2244

Well-known member
Joined
Nov 11, 2006
Messages
14,065
The books published by "Sunset" at the local big box will get you through anything you should attempt.
 

mrb

Well-known member
Joined
Dec 31, 2008
Messages
3,734
i applaud your desire to learn, but I have a feeling your house will present you with situations not covered in these books ie: the grounding.

also, whats this 240v compressor line underground?
 
To avoid these ads, REGISTER NOW!
OP
D

d33pt

Well-known member
Joined
Oct 26, 2008
Messages
547
i applaud your desire to learn, but I have a feeling your house will present you with situations not covered in these books ie: the grounding.

also, whats this 240v compressor line underground?

the 240v line runs from my house roof to the detached garage roof. I want to put it underground.

I plan to put in new grounded circuits, and leave the old stuff alone. The books should cover that.

It's not rocket science right? I can do this.


(famous last words)
 

Charles (in GA)

Well-known member
Joined
Jan 11, 2006
Messages
12,489
Location
50 mi south of Atlanta
the 240v line runs from my house roof to the detached garage roof. I want to put it underground.

I plan to put in new grounded circuits, and leave the old stuff alone. The books should cover that.

It's not rocket science right? I can do this.


(famous last words)

Is this the only power going to the detached garage? If there are other circuits, code only allows one circuit to a detached structure, in which case you need to run a suitable sized sub feed to a sub panel in the garage and power everything off of that.

Charles
 

mrb

Well-known member
Joined
Dec 31, 2008
Messages
3,734
the 240v line runs from my house roof to the detached garage roof. I want to put it underground.

I plan to put in new grounded circuits, and leave the old stuff alone. The books should cover that.

It's not rocket science right? I can do this.


(famous last words)

no its not rocket science, but it is not as simple as some make it out to be -not to mention it is possible (and common) to have a very dangerous situation and never realize it because 'it works'.

give some more detail about what you are doing, and post a picture of your existing panel (s) with the cover off.
 
OP
D

d33pt

Well-known member
Joined
Oct 26, 2008
Messages
547
there's a 120v circuit going to the garage too.

as soon as it stops raining here, i'll take some pics of what i'm dealing with. it's a mess, and i'd like to clean it up.

i suspect it may be one of those "it works" situations that i have currently.
 

mrb

Well-known member
Joined
Dec 31, 2008
Messages
3,734
cant have both a 120v and 240v circuit going to the garage. you're going to have to install a subpanel. 4 wires (hot-hot-neutral-ground) from the house to the garage, seperate neutral and ground bars in the subpanel, two ground rods, and bond any metal piping. All 15 and 20 amp 120v receptacles have to be GFI protected (best way is first receptacle in a string and feed the others from the load side of the GFI receptacle)
 
OP
D

d33pt

Well-known member
Joined
Oct 26, 2008
Messages
547
i might have to run a whole new line from the main panel then. the 240v lines look to be about 8 or 10ga. not sure if that's beefy enough to run both the compressor and all the 120v stuff.
 

mrb

Well-known member
Joined
Dec 31, 2008
Messages
3,734
i might have to run a whole new line from the main panel then. the 240v lines look to be about 8 or 10ga. not sure if that's beefy enough to run both the compressor and all the 120v stuff.

you will anyways as you need 4 wires and the compressor is only going to have three (presuming there is a ground)
 

mkbrower

Active member
Joined
Aug 11, 2010
Messages
44
Location
Foot Hills of North Carolina
I was a Navy electrician so I had a grasp on electrical theory and wanted to to tackel the wiring for a complete remodel of my kitchen. I bought several "how to" books but "Wirng a House" by Rex Cauldwell is by far the the most complete and easiest to understand with lots of drawings, charts and pictures

Mark
 
To avoid these ads, REGISTER NOW!
Top Bottom