To avoid these ads, REGISTER NOW!

Ground Fault problem

Bear

Well-known member
Joined
Feb 12, 2007
Messages
557
Location
Salem, Oregon
Not exactly a shop deal but I rebuilt the deck behind the house this spring and that required removing the hot tub. After reinstalling it I am having a problem with the ground fault part of the SQUARE D HOM2-4L50R 50AMP 120/240V SAFETY SWITCH box. I am pretty sure I have all the wiring hooked up the same as before so am a bit at a loss as to what I have wrong.

Ideas???
 
To avoid these ads, REGISTER NOW!

Rob_b

Well-known member
Joined
Jul 28, 2009
Messages
209
Location
Ontario Canada
Details man, details...
whats going on...tripping, no power, etc? Are you using the same cable as before? :confused:
 

wyliesdiesels

Well-known member
Joined
Aug 14, 2012
Messages
20,253
Location
Modesto, CA
Take pics of your GFCI breaker and post 'em. I'm guessing u have the neutral from the tub connected to the neutral bar instead of the breaker!
 
To avoid these ads, REGISTER NOW!
OP
B

Bear

Well-known member
Joined
Feb 12, 2007
Messages
557
Location
Salem, Oregon
Check the obvious stuff first. Is the neutral from the tub connected to the breaker or the neutral bar?

Ground is to ground bar on each end - neutral (white) is connected to neutral hub at each end (tub and breaker). Two hots at each end - black and red.

When breaker is set to "ON" all is good until ground fault button pressed, then breaker goes off.

This is new cable - same size as before only longer as tub moved about 4 ft.
 

frankush

Well-known member
Joined
Oct 23, 2011
Messages
1,156
Location
IL
Are you sure that your GF buton is not the test button to see if the GFI breaker is working properly? Pushing the test button should trip the breaker.
 
OP
B

Bear

Well-known member
Joined
Feb 12, 2007
Messages
557
Location
Salem, Oregon
Are you sure that your GF buton is not the test button to see if the GFI breaker is working properly? Pushing the test button should trip the breaker.

Jeeze - maybe your right. I best go try the pump etc.

here's the pic's
 

Attachments

  • hot tub.jpg
    hot tub.jpg
    25.1 KB · Views: 21
  • breaker.jpg
    breaker.jpg
    23.5 KB · Views: 24

LXCam

ALLIANCE MEMBER
Joined
Apr 23, 2013
Messages
19,407
Location
AZ
The push to test function is a standard on all gfci breakers. And like ^^ stated, that'll trip the breaker.
 
OP
B

Bear

Well-known member
Joined
Feb 12, 2007
Messages
557
Location
Salem, Oregon
Thanks to frankush - sometimes us old folks get stuck on one line thinking.
Sooooo - getting my head out of my azz I checked and there is power to the tub but the display/control panel is not responding.

Guess I need to find the book and chase it some more tomarrow.

Thanks to all for your thoughts.
Bear
 
To avoid these ads, REGISTER NOW!
Top Bottom