Half Assz Weld/Fab Table

[ssffnomad]

Back last year, i went to buy a Vise. Guy was moving , basically made me take 30"x7' w/ 1/4" Steel Table. It was way too big and hard to move. So i cut it in Half , made two Tables and gave one to my Buddy.
I was using cheat Sears Box to roll Chop Saw and Grinder outside. I always hated that thing. Giving it to a Friends young son.

As you can see what Material i had laying around. I like doing Dirty Stuff on Apron in front of shop.
It will fit nice between Overhead Doors. Want to Mount Ground stud and Power strip.

 

[CNGsaves]

So did you piss off the "Terminator" or what . . . . AND . . . he punctured your vise with a giant bolt and yanked out the handle??

 

[bams50]

I hope that 1/4" top isn't too heavy. It might be too much for that thin wall angle iron.

Usually a welding table will get heavy items and heavy pounding. Those legs won't take much more by the time you get a vise mounted.

 

[Drew_flux]

I dont know, your table looks the goods for light use, I think you may have been using your whole *** on this project. you might want some diagonal brace's for more frame strenth though.

 

[NUTTSGT]

I like it, start using it and see if it holds up to heavy use.

 

[ssffnomad]

the Vise was missing Pin, i have this one made now, Just Need to cut down . I have a much bigger Vise mounted to HD Stationary Bench. Basically have no money in it, i had the scrap steel, buddy gave me Casters. This will do just fine for my intentions, primarily getting alot of dirty jobs outside.