Hanging style heater help

[Dale]

I acquired an older peerless unit heater (Model LUH 50c.) The cover with the wiring diagram was the only part missing. I can easily make a new cover , but I am in dire need of the wiring diagram. Some of the wires were not hooked up.

 

[Torque1st]

Have you checked with the manufacturer?

 

[Dale]

Apparently the maker is no longer in business.
Thanks,
Dale

 

[Torque1st]

Try http://www.peerlessheater.com/ which redirects to Peerless Boilers at http://peerlessboilers.com/.

There are hundreds of distributors of Peerless heating equipment. Any HVAC technician should be able to hook the unit up in a few minutes.

 

[Dale]

Peerless heating that you referred to does not nake this type of gas fired unit. On their FAQ page they address the issue and give you a contact that is no longer current.

 

[Torque1st]

Track down the contact, or call the boiler co & see if they have a current contact. Remember manufacturers are required to support their equipment for many years depending on type. As I said any HVAC tech could hook it up in minutes. That old stuff is simple. When he gets it connected make your own diagram.

 

[Kevin54]

Are you positive that is tthe correct Model # and correct spacing between the numbers? A search should bring something up and that number gets no hits whatsoever

 

[buening]

My guess is it is similar to these, just made by peerless back in the day: www.heater-supply.com/luh.pdf

What exactly isn't wired up? Any pics of the wiring that you need help with?

 

[D KRAGER]

Yea an old hanging gas furnace shouldn't have too many wires on it.

It most likely has a 24 volt transformer, it's simply a loop system, thru the thermostat, thru the high limit switch, to the gas valve.

Then on the fan wiring it should be 110 v and should run to a fan theormostat that kicks the fan off and on depending on the pendulum temp.


Well this all depends... is it gas or all electric heater???