Hanging tool roll with wrenches on wall

[elcom]

Question, is it safe to hang a proto wrench set on the wall using the provided grommets? It seems the intent, but I wonder if it withstands permanently hanging on the wall.

Setup similar to this (below), wrenches are relatively heavy.



Thanks!

 

[FMB4]

I'd hang each wrench on its own hook myself. Otherwise, I'd place all 5 riveted holes on separate hooks.

 

[General Geoff]

Not a problem. I have a set of Proto ratcheting wrenches in the original tool roll hung up in my enclosed front porch turned motorcycle garage, been hanging for the past three years with no ill effects.

 

[elcom]

Not a problem. I have a set of Proto ratcheting wrenches in the original tool roll hung up in my enclosed front porch turned motorcycle garage, been hanging for the past three years with no ill effects.

Thanks! Do you have a hook in each hole or just a couple? Is yours a large set like this or a smaller set?

 

[General Geoff]

Mine is a slightly smaller set going 6 - 19mm, I hang mine with three hooks. One on each corner and one in the middle.

 

[M635_Guy]

If you use them a lot, it seems like the plastic sleeves would eventually start breaking. If they're more occasional, I'd probay have three or four hooks in a spot where I could hang it when I needed it

If I wanted them up on the wall long-term, I'd probably find a tidy way to hang each one, but that's just me.

 

[B_Bimmer]

The cold weather is hard on the plastic and they almost all fail the first winter around here.

 

[Indexmill]

I recommend not.. if you care about the roll.