Harbor Freight 5 drawer tool cart question

[Fire&Steel]

I have a simple question for anyone who owns a item#95272 http://www.harborfreight.com/five-drawer-service-cart-95272.html

How many screwdriver holes are on each side of the box? I can not find anyone who says it in there review.

 

[gmt]

I don't have the 5 drawer cart, only the 4 drawer cart, but from some pictures in the HF cart mod thread it looks like there are 11 holes on each side.

 

[neel2008]

damn I was just there yesterday looking at them. I didn't even realize they had screw driver holes until then. Id say 11 on each side would be about right from what I remember seeing. I didn't count them. I also should have paid attention to the height between the top of the hole and the top of the lid so I would know if my smaller pry bars would fit in there as well.... GMT, does your's have two levels of holes? Can't remember that about that either....

edit: Just watched the video again, I counted like 9 or 10 screw driver handles on the right side, it was hard to see, but it does kind of show you in the video if you haven't watched it yet.

 

[gmt]

neel2008, the 4 drawer cart only has 9 holes on each side and there are 3 different size holes on each side. The holes are at the same level on both sides. The distance on the screwdriver holes to the cart lid is also less on the 4 drawer cart than on the 5 drawer cart.

 

[SlowAl]

There's 11 on each side. They seem to be drilled out in metric sizes instead of SAE. I measured them and there were three 25mm, four 20mm and four 12mm. None of them seem to quite reach a common inch size.

 

[Fire&Steel]

Thank you

 

[neel2008]

thanks gmt and slow