I'm still about a half a bubble off, but I'm pushing through!
Yesterday I had to dig banana trees and divide them, that was a job, the root system exists of rhizomes and fibrous roots, the rhizome was the size of two 5 gallon buckets and very hard to cut.

I divided it into five trees.

Three are here and one back by the storage shed, Dude got the fifth one!
I started working on the shed roof again today but! I didn't have electric in that area and Dewalt was going dead faster than damnit.

So I decided to change up and be a sparkey today!

When I added the right lean-to to the shop I ran a 15 Amp and a 20 Amp wire out the back knowing I would need power later! So I added a junction box and some conduit, the four gang is the 20 Amp circuit, I will add more conduit and outlets across the back wall later. I put all of this in conduit because the squirrels are really bad behind the shop, I have had to dispatch a few for chewing things back there!

The 15 Amp circuit goes to the existing wiring that was in the carport from when it was next to the house.

There is an on/off switch and a motion detector on that corner that operates the four ft. LED in the top center. And an outlet so that I can run the corded circular saw.
Last week I put up some fence to keep the chickens out of the flowers.

It doesn't seem to bother the girls, they kinda roll with the flow.

I bought a new toy, best deal I ever got on marketplace hands down! It has 237 hours on the clock, no spark but great compression. The complete electrical system is 140 bucks so no worries!