Head swapping dual 80 flex?

[MachineTech]

I have two speeder ratchets in 1/4 and 3/8 drive:

FSLF936

TSLF936

I'm not certain these are available anymore although I have seen a couple on ebay. I think they were discontinued and when I punch in the part # on the Snap on web site it says this item is no longer available. These were made before dual 80 technology. Is it possible to obtain just a dual 80 head? If it is, is there any reason that I couldn't swap out the old heads for two ratchets? Anyone done it?

 

[Fedwrench]

I took a head off of a FLF80 and stuck it on a FHF936 without any problems. I wanted a shorter fine tooth flex head ratchet. I was able to pick up a second FLF80 ratchet cheaply on Ebay before all of the hype started. The heads come off by removing the screw and boths models used the same wire washer for tension. I checked the Snap on parts site for head price and availability and they don't list and parts for the FLF80 ratchet. Perhaps a dealer could help.

 

[MachineTech]

Thanks, I'll talk to my tool man about locating dual 80 heads.