Heat for pole barn question

[outsider347]

Just finished my pole barn and looking for info how to correctly connect the flue thru the wall of the building.

The outside wall material is the standard steel material used for pole barns. Inside is R-19 kraft faced insulation covered with the same steel wall material, but lighter gage.

My heater is a older Janitrol hanging unit heater 125K BTU 5 inch flue

I'd like to run the flue thru the wall, not the roof

What do I need?
Where should I purchase the pieces
Tks
ed

 

[outsider347]

Ttt

anyone??

 

[Rookie2]

need to use 'B' flue pipe and a thimble

http://www.ventingpipe.com/type-b-gas-vent-pipe/c1760

one problem is that you need to turn it up 90 deg. or moisture will enter the soffit .

 

[Mike007]

My guess based on the limited info provided, you will need a draft inducer mounted on the exterior wall since your unit more then likely is not a direct vent unit. It would be more cost effective to vent it through the roof or buy a unit that is designed for direct-vent applications.