Rybaadaj
Member
Hello GJ---long time lurker here. This forum has been a mix of bad and great influence for me ever since I decided to make my workspace (garage) a little less chaotic (a lot, actually). I've never had anything to give back to the community, but wanted to say thank you (and hello, finally!) for all the great organization ideas and tool & equipment advice.
A little about me: Engineer (socially and professionally); prefer to never call in a pro to fix anything at my home or in my vehicles (02 WRX and 6.4 F350); and my goals when I come to GJ are often aimed at expanding my capabilities/skills in my shop or helping make sure that the next ___ I buy is the last ___ I ever have to buy (Made in USA preferred but not exclusive).
Thanks for reading!
P.S. I just found a 1/2 HP block grinder (397.19460) with original stand in great condition and all attachments (except quench tray?) and love it! Thanks again for the guidance. For some reason the PO sliced any mention of "Craftsman" off the label
A little about me: Engineer (socially and professionally); prefer to never call in a pro to fix anything at my home or in my vehicles (02 WRX and 6.4 F350); and my goals when I come to GJ are often aimed at expanding my capabilities/skills in my shop or helping make sure that the next ___ I buy is the last ___ I ever have to buy (Made in USA preferred but not exclusive).
Thanks for reading!
P.S. I just found a 1/2 HP block grinder (397.19460) with original stand in great condition and all attachments (except quench tray?) and love it! Thanks again for the guidance. For some reason the PO sliced any mention of "Craftsman" off the label