help i.d. a air pressure regulator

[sweetk30]

EDIT : thanks to fellow member I got the parts needed .

I have this regulator in my shop and the diaphragm was dry rotted and leaking out the body were it bolts together.

there was a tag some time ago but I have no clue to its brand .

1" inlet/outlet
2-1/8" ports 90* from the in/out
bolt pattern is 10 bolt / 4.40" 1 to other 180* across / and 1.33" bolt to next bolt hole.

the top cap is a 3" bore inside and the body has a 11-002-097 stamped in the top by the bolts .

the diaphragm has a aluminum plate with 1 rivet in the center with a hole in it. the plates 3.25" dia.

the bottom section of the body is 3.61" bore inside and a little pad with 476 in side . the very bottom center plug does also unscrew and a spring inside for the tiny pin in the center that plugs off the center rivet hole in the diaphragm .

would be nice to just get a new diaphragm for it . I was finding some but there looking at over 100 bucks for a whole new unit.

thanks for any leads / help .

 

[sweetk30]

last few pics.

 

[larry_g]

http://www.ebay.com/itm/11-002-097-...cision-Regulator-Valve-11002097-/291589239515

http://www.ebay.com/itm/Norgren-Pre...992038?hash=item3f6006b566:g:CqEAAOSwZ8ZW-Hqm

I believe your regulator is an older Norgren unit. You would have to confirm that the kit above will fit your regulator. I think you have a relieving regulator and the kit may be for a non-relieving one or it may fit both.

lg
no neat sig line

 

[sweetk30]

why thank you sir .

on my watch page for later . . might just grab it at that price.

and I see your edit and raise you another

that be my ticket there .

and this is why good chat forums help each other in there specific fields we each know best !

just went out and popped the bottom plug out and that reman kit is the TICKET