You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Help id this compressor pump.
- Thread starter 930dreamer
- Start date
Jswain
Well-known member
Looks like a Saylor Beall 707 and or a clone of it
kams1973
ALLIANCE MEMBER
Agreed. SB707 or Clone. Generally considered a 7.5hp - 10hp pump. Looks like the flywheel is broken.Looks like a Saylor Beall 707 and or a clone of it
The Tool Tyrant
ALLIANCE MEMBER
I concur..SB 707. SB pump sheaves are beefy cast units and don't break without 'help', which more often than not happens when a compressor hits the ground. If you're thinking of purchasing it, be sure to run a dial indicator on the end of the crankshaft to check run-out.
OP
I do see where the flywheel is broken, that is unfortunate.
The Tool Tyrant
ALLIANCE MEMBER
Here is the correct sheave for a 707... https://oemaircompressor.com/Saylor-Beall-ReplacementPart-6445.aspx
Jswain
Well-known member
And if it is indeed a clone then it will likely be a different size you will have to measure the od of the shaft.
Looks like the top of the motor pulley is broke as well so that tells the story of what happened im sure lol
Looks like the top of the motor pulley is broke as well so that tells the story of what happened im sure lol
OP
My job will be to list this on Marketplace, known issues will be pointed out.