Help me get my drawers out please!

[SpannerMonkey]

Hi,
I bought this toolbox:

I don't know what make it is but has Accuride slides. I want to remove the drawers but I can't see they come out. Help please!

 

[CharlieM]

http://www.accuride.com/Woodworking/Resources/Disconnect.asp

 

[SpannerMonkey]

Yeah, thanks but I checked the Accuride site already. None of those systems matches the slides I've got.

 

[allinon72]

Are they friction slides were you just pull them out firmly?

 

[Hpozzuoli]

Can you take a pic of the font edge of the rail that is attached to the inside of the box.

There has to be a release, if not there should be a hole in the slides where you can pull it up off the track.

 

[larry_g]

In the last picture have you pushed a pin into the small round hole to release a catch?

lg
no neat sig line

 

[Alexbn921]

The slides look permanently attached to the drawers. The front part is riveted and the slides do not have a release point in the picture. You might be able to get the whole drawer slide assemble out.
Extend the draw all the way and pull up to release the front of the slide from the box, then pull out to release the rear attachment.
Use a sharp upward pull or a dead blow hammer.
The ones on my snap on, and mac where friction fit.

 

[zkling]

First off that looks like an awesome tool box.

I'm fairly certain those slides are one piece and you will have to drill the rivets to remove the drawer. Call accuride to verify that though. Those are ball bearing slides and pretty complex and $ to replace. Prying around on them can really do permenante damage to the slides, the you will really be SOL. You can try Alex's suggestion above, but I wouldn't be surprised if both the drawer side and the box frame side were riveted.