Help removing wire From Conduit

[AP514]

I most likely will use this a few feet below the Panel to break out the Fiber Cable.
I will just drill a hole to 1 side of the top center for the Fiber to come out of..
https://www.homedepot.com/p/Cantex-1-Gang-FSC-Electrical-Box-R5133464/202043350

 

[BillK]

Just curious . . . . I did not think that was allowed by code ?

 

[mike93lx]

Just curious . . . . I did not think that was allowed by code ?

Two feeds aren't allowed but a switch loop is ok if it originates and terminates at the dedatched structure, AFAIK

 

[wyliesdiesels]

A switch loop for a 3-way light circuit breakered in the garage and switched in the house is permissible.

Since the source is the garage panel, there isnt 2 feeds to the garage.

 

[AP514]

I knew my Electric guy did a good job....Too bad he did not put in 2 extra 3/4 drops ...But then again I never thought to ask.

Also just to be Clear the "Fiber Cable CAN NOT run thru my C/B PANEL in Garage".
Even if it just passes thru .....

 

[wyliesdiesels]

correct fiber cannot go through the panel

 

[AP514]

I ran the Fiber Cable thru Panel any way.....

 

[Jim greengo]

Low voltage is normally run seperately.

 

[Muzzy]

I ran the Fiber Cable thru Panel any way.....

Why would you post that after being told multiple times it was wrong?
Not sure that makes you a badass.

It was mentioned the shielded cable was for the garage door opener? Can you test voltage on it, specifically if it is AC or DC. If it was AC it wouldn't bother me too much being in the same pipe from an interference standpoint. The insulation on it probably wants to be the same voltage rating as the other conductors in the pipe though. Where is the shield landed?