I picked up at an auction and have wanted to get going. It's a 4SF40GH1
The diagram online shows a By-pass inlet right next to the pump inlet. The brass part and spring below were screwed into it. I think the other piece on the right was too, but was loose and fell out.
The top part in the brass screw pulls out, but is a little corroded. I'd replace it if I knew what it was called. Is the little part on the right supposed to go into the screw hole of the brass nut? It doesn't seem to want to screw in at all.
Thanks,
Rich
The diagram online shows a By-pass inlet right next to the pump inlet. The brass part and spring below were screwed into it. I think the other piece on the right was too, but was loose and fell out.
The top part in the brass screw pulls out, but is a little corroded. I'd replace it if I knew what it was called. Is the little part on the right supposed to go into the screw hole of the brass nut? It doesn't seem to want to screw in at all.
Thanks,
Rich