To avoid these ads, REGISTER NOW!

Hey All...........

To avoid these ads, REGISTER NOW!

Runum

Well-known member
Joined
Feb 4, 2005
Messages
182
Location
DFW
Welcome. Glad you could make it. Got any pictures of the vette? :beer:
 
To avoid these ads, REGISTER NOW!
OP
J

JLMvette73

New member
Joined
Jul 29, 2005
Messages
2
Location
Indiana
Runum said:
Welcome. Glad you could make it. Got any pictures of the vette? :beer:

Just a couple of us unloading it after picking it up in St. Louis earlier in the day. I'll post one of them, and post a better one later after I get a chance to take some better pictures.

ChucksCrib said:
:rocker: Another 'Vette

Two of them, actually. I just bought the '68 big block 4 speed convertible that I'm using a picture of for my avatar at Bloomington Gold this year. I've also got a '73 small block coupe that I've had for 19 years.

I built a 24' x 30' garage with 10 foot ceilings last year to keep the vette(s) in. Other than installing the heat (electric forced air in the attic), some of the wiring and insulating the ceiling I really haven't done much with it yet. Hoping to get some good ideas here. I did install a floor drain and run it to my old finger system along with a drain for a sink. I also ran a piece of 4" plastic pipe under the footer and up through the floor to run a water line through. It's on it's own electric meter with 200amp service. Wanted make sure I had plenty of capacity for a welder, compressor, etc.
 

Attachments

  • jerryvet.jpg
    jerryvet.jpg
    74.7 KB · Views: 86
  • 68OnTrailer1.jpg
    68OnTrailer1.jpg
    91 KB · Views: 83
To avoid these ads, REGISTER NOW!
Top Bottom