High flow 1/4" Air compressor regualtor needed

[mroneeyedboh]

So I'm onto getting an Account, the Husky ( or the like) it's a 120v unit. Looking to run nailer, impact etc on it. No die grinders etc. I know the regualtor thst comes on them aren't good. Is it worth upgrading the regualtor? If so to what?

I have an ARO 2000 unit here but I don't know how much pressure loss or cfm loss I'd get, if any at all.

What ya guys think

 

[gdocktor3]

Use the aro 2000 if you want, otherwise leave it alone.

 

[bsaint]

Any 1/4 full size regulator will have plenty of flow

 

[mroneeyedboh]

Thanks. I wasn't sure if it was a bottle.neck or not

 

[ItsNemo]

Any 1/4 full size regulator will have plenty of flow

This. Most regulators will be fine for light duty use. The impact can benefit from a bit more flow but odds are with a small 120v compressor you'll be restricted somewhere else more than the regulator.