Hone for MT2?

[Thumper68]

Does anyone know where or if I can get a hone for a female MT2, there is a slight burr in one of my drill presses and would like to hone it smooth.

I can find MT2 reamers but no hones.

 

[A_Pmech]

For such problems it's usually easiest to file it down with a round file and stone it smooth.

 

[Thumper68]

For such problems it's usually easiest to file it down with a round file and stone it smooth.

That's what I tried to do today, but since it is a female part I can't see it well enough at the same time as reaching up inside to do it, I can feel the burr with just the tip of my finger.

Sorry that sounds so wrong

Hmm while I was typing that it came to me that I could wrap some fine emery around a MT2 shank and try and hone it with that.