To avoid these ads, REGISTER NOW!

House has multiple unconnected ground rods. Best fix?

ScaldedDog

Well-known member
Joined
Jan 15, 2008
Messages
1,068
Location
Sedalia, CO/NSB, FL
My home has two ground rods: One for the main service entry (at left in the photo below) and one installed by the fixed wireless internet provider years ago (at right in the photo below). The fixed wireless grounding block is grounded to the second rod, and I used it when I installed my Ubiquiti bridge node when we moved in six years ago.

20260804_145750 (with text).jpg

As I've been researching grounding a yet-to-be-installed Starlink antenna, I've discovered this setup is not correct, and could be dangerous. True? If so, what's the best way to resolve this?

I can think of a couple of options:

The quick and dirty way would be to just connect the two ground rods with a 10 gauge wire. Is that acceptable?

The second way would be to run longer ground wires from the grounding blocks (shown better in the photo below) to the service grounding rod (shown better in the second photo below)
20260804_145902.jpg

20260804_145832.jpg

Mark
 
Last edited:
To avoid these ads, REGISTER NOW!

bob smith1

Well-known member
Joined
Jul 2, 2026
Messages
126
It's always the IT group that makes a mess because they have no permits to pull. Yes, connecting the rods is the best strategy, but not with #10. #6 and I would like to see it in a conduit for protection. What you have now is "potential for potential"....lol Meaning likely voltage between those two rods. Just connect them.

But if I was a betting man, any of those IT guys didn't bury much of a ground rod, probably a 12" sliver to 'look' like a ground rod.
 
To avoid these ads, REGISTER NOW!
To avoid these ads, REGISTER NOW!
Top Bottom