How far from the corner?

[duffer]

I'm new to the forum and getting ready to hang my 50 btu mr heater. How far from the side walls and the corner should i go. In the pics you can see where my beams are ,I bought unistrut to put over the beams in the attic and threaded rod to hold it. thanks in advance for the advice. I will run gas and elec. after hanging.

 

[kenfath]

That information can be found in the instruction manual.

 

[aardquark]

Here are some offsets I came up with, for a heater 25" wide, with 18" offets to nearest walls:

 

[soapii]

That information can be found in the instruction manual.

X2 all manufacturers list the clearance specs in their manuals.

--Joe

 

[duffer]

Thanks aardvark that helps out a lot…you must be an engineer.

 

[6768rogues]

The instructions and listing from the manufacturer should be followed. I like rules of thumb, but the manufacturer's information is the holy grail.