How is everyone hanging their tin signs

[Joe Cool]

I am finally at the point where I can put up my wall art in my new garage. This is the first time that I am hanging tin signs and banners on finished drywall and am curious if there is a cleaner way than using nails.

Looking for ideas.

 

[340wedge]

I use small screws, and sometimes a light chain. Great Mopar signs BTW!

 

[GCncsuHD]

I just used small nails for all of my tin signs and banners. Anything that was heavier I used those Walldog hanging screws.

IMAG1086 by Garrett, on Flickr
IMAG1088[1] by Garrett, on Flickr
2015-09-14_12-21-26 by Garrett, on Flickr

 

[rburke65]

One has only a handful of options.....nails, screws, chain, magnets, shelf ledges. That's about it in my book.

 

[Jeff Ivers]

Sheetrock screws through cup washers is a great way to go.

 

[1949 caddyman]

Another vote for drywall screws. Much easier to remove down the road also.

 

[ratdoggy]

Sheetrock plastic anchors and screws...
Not rocket science.
I did put most of my signs and license plates at the top of the wall and screwed them into the top plate with drywall screws..
That also made them straight .This is an old picture BTW

 

[cajunfirehawk]

Sheetrock plastic anchors and screws...

Ditto, I use the anchors that actually screw into the drywall and then the screw screws into the anchor, best things ever!

 

[Scud67]

I just used "tek" screws. Worked pretty well.