how to set up arm locks on bendpak

[ADSR]

Guys, I have one arm on my hoist that will not drop in to the lock. I've tried many positions, but it's a no go. Has anyone ever adjusted their locks?

 

[rburke65]

On a Bendpak!? Wow.......those are usually bullet proof.

 

[ADSR]

I'm going to have to take it apart. I'm thinking the bolts might be cammed.

 

[Jeep07]

There is a left and right if its an asymetrical. The locks/Teeth bolt onto the arms to align with the lock on the pin. If I remember right I had to flip one to get mine to align correctly and fully engage at all parts of the swing.

 

[zkdiesel]

Is this an In use failure or initial setup?

 

[ZipSnafu]

On mine,occasionally, the locks will turn a little just enough to not drop when the lift arms are off the ground.

 

[ADSR]

Is this an In use failure or initial setup?

I don't believe so, as the lock worked in all positions for 2 years. Now, not so much.

 

[ADSR]

There is a left and right if its an asymetrical. The locks/Teeth bolt onto the arms to align with the lock on the pin. If I remember right I had to flip one to get mine to align correctly and fully engage at all parts of the swing.

I'm going to pull it off and have a good look at it.