ID this Craftsman Lathe!

[930dreamer]

I spotted this on CL.

 

[LB-1911]

My wag -
103.23880
http://vintagemachinery.org/photoindex/detail.aspx?id=13362

 

[Packard V8]

The stand might be worth having. I wouldn't take that lathe as a gift.

jack vines

 

[bluebolt]

Those round tube Craftsman lathes are held in low regard LOL.

Now that stand uses two bench grinder pads on the top, I would get it if price was reasonable and use it with two Craftsman block grinders!

 

[930dreamer]

Those round tube Craftsman lathes are held in low regard LOL.

Now that stand uses two bench grinder pads on the top, I would get it if price was reasonable and use it with two Craftsman block grinders!

$100 on CL, no tool rest.

 

[bluebolt]

$100 on CL, no tool rest.

Yeah I would go after it if I were closer!

 

[nine4gmc]

Those round tube Craftsman lathes are held in low regard LOL.

Now that stand uses two bench grinder pads on the top, I would get it if price was reasonable and use it with two Craftsman block grinders!

The top plates are not grinder top plates(unless someone changed them), they are made specifically for the 6" jointer and the poles are too low so you would need to get new longer poles too. I had that two pole stand under my table saw when you came by. If you really want it, I will hold it for you next time you come by or I get up that way. I was planning on selling it or parting it out(the base not saw) since I have the table saw pole base now.

 

[930dreamer]

This is at the Restore in Abq, NM.

 

[bluebolt]

The top plates are not grinder top plates(unless someone changed them), they are made specifically for the 6" jointer and the poles are too low so you would need to get new longer poles too. I had that two pole stand under my table saw when you came by. If you really want it, I will hold it for you next time you come by or I get up that way. I was planning on selling it or parting it out(the base not saw) since I have the table saw pole base now.

Take a good look at the plates, they are the grinder plates. The lathe stand is not the same as the jointer stand. I don't know about the height though. They look taller for the lathe stand though.

Page 33 here.
http://www.blackburntools.com/artic...ears/pdfs/sears-craftsman-1966-power-hand.pdf

 

[nine4gmc]

Ah, my bad, I did not know there was an actual lathe stand.

 

[jakemac]

This is at the Restore in Abq, NM.

Awwww, that poor bandsaw. It's playing dead.

 

[bluebolt]

I wish you had a few more pics of that mobile saw and joiner stand 930!

 

[930dreamer]

I wish you had a few more pics of that mobile saw and joiner stand 930!

Here's the last one, it think this is about $80?

 

[nine4gmc]

Looks pretty well thought out.