ID this newer Wilton

[PoorOwner]

Does anyone know what series and size this vise is?
It lacks pipe jaw so it isn't a tradesmen or C, so it's a swivel machinist?

The table top on the second picture is 28" across the picture.

 

[M_George]

Looks like my Tradesman. Check and see if there are recessed areas with a threaded hole where the pipe jaws could be mounted.

 

[zkling]

Standard 3.5"-4.5" s. Probably a 400s "machinist" series.

 

[GRB]

Machinist. Size would be the vice width. 400 would be 4.0 inch jaw width. Much stronger than tradesman and as strong as a Combination but without the height and bulk. Downside is no pipe jaws of either of the others.

 

[exmaxima1]

Swivel Machinist without a doubt. Pre-1999 as it has the smaller rear dust cap.