Identifying a snap on box

[Olholland]

Hey fellers, bought this snap on box for 400 bucks and threw a half inch plate of aluminum on top for a work surface. The lock was drilled out when I got it and I’m trying to get a new one but I can’t figure what model it is. I checked for stampings as previously stated and didn’t see any, it used to have a sticker that was removed. Any more advice? Thanks in advance and I’m excited to be here.

 

[Lookin4'67Galaxieconv]

The sticker replaced the box identification, in the past it was a slight engraving. That looks like a KRA box to me, but I'm not knowledgeable on the numbers. I'd do a Google image search on 'Snap On KRA tool box' until you find a couple examples with the number, then Google that number to verify.

Or just wait for someone here to tell you.

 

[Wrench97]

Look on the rear of the box, that one is old enough it should have the stamping.
How wide is it 55" or less?

 

[rhastings80]

Looks like a KRA5213D

Pull out the bottom left drawer. There might e a sticker under there.

 

[KnurledNut]

Looks like a KRA5213D

Pull out the bottom left drawer. There might e a sticker under there.

I was thinking a 2312 and someone moved the top drawer down two spaces.

 

[Olholland]

Look on the rear of the box, that one is old enough it should have the stamping.
How wide is it 55" or less?

Just under 55

 

[Olholland]

Looks like a KRA5213D

Pull out the bottom left drawer. There might e a sticker under there.

I’ll clean it out on break today and let you know

 

[TJMtl]

Great work surface!

 

[Olholland]

Looks like a KRA5213D

Pull out the bottom left drawer. There might e a sticker under there.

That sticker is long gone but thank you it does look like a kra5213d my snap on distributor agrees

 

[KnurledNut]

@Olholland
Can’t be. The 5213 has 13 drawers. Yours has 12, like the 2312.

 

[Wrench97]

Model Description Sq. In. Cu. In. Load Width Depth Height Net Wt. Caster Drawers
KRA2312 Roll Cab 5,231 20,418 1,320 lbs. 53 " 19 ½ " 38 ½ " 351 lbs. 5 x 2 " 12