IR 7.5HP Capacitor wiring. RESOLVED

[the common user]

RESOLVED
I picked up this air compressor and the seller said the motor was bad. I powered it up and it ran briefly. After checking, I found the capacitors were bad, and it looks like someone had already replaced the run capacitor at some point. I installed all new capacitors and wired everything the same way it was before. Now it runs longer, but then it burns out one of the start capacitors and trips the breaker.
I also need help making sure the wiring is correct. Any ideas on what could be causing this?

 

[mm08822]

Check the centrifugal switch. Could be stuck closed.

 

[the common user]

Check the centrifugal switch. Could be stuck closed.

Other than that does the wiring look correct?. It has 2 start cap and 1 running cap.

 

[BillK]

Why would you not just call or e-mail Ingersoll Rand and ask them for a wiring diagram ? Seems like they would know better than anyone here.

https://www.ingersollrand.com/en-us/products/air-compressors/

 

[wyliesdiesels]

how are you powering it? mag starter? I doubt it has integral OL protection...

 

[the common user]

Why would you not just call or e-mail Ingersoll Rand and ask them for a wiring diagram ? Seems like they would know better than anyone here.

https://www.ingersollrand.com/en-us/products/air-compressors/

I was able to get a hold of someone after 2 hours on the phone.

Wiring is correct so I need to check the centrifugal switch.