IR Air Tools

[JayL]

I came across these and I thought I might post it for those who are looking to make a purchase.

http://www.sears.com/shc/s/p_10153_...me=Mechanics+Tools&sName=Automotive+Air+Tools

http://www.sears.com/shc/s/p_10153_...me=Mechanics+Tools&sName=Automotive+Air+Tools

I had been waiting a long time for this angle grinder set to be back on stock. Too bad it came when I already purchased their CP equivalents.


http://www.sears.com/shc/s/p_10153_12605_00919559000P

 

[eschoendorff]

Thanks, but in the states, those are available from a variety of vendors.

 

[JayL]

If only I had known earlier. I wanted the IR grinder kit 2 months ago and did'nt know any other vendor selling it except sears so I went for CPs.

 

[eschoendorff]

CPs aren't a bad buy either....

 

[JayL]

Yeah but for the price of the IR kit offered by sears you get the pads and accessories kind of free ..

 

[ImportTuner]

For what Sears want for the IR 2131, you would be better off buying the IR 2135 (for the price).

 

[brantjs]

Does anyone know which models actually come in the Sears die grinder kit? The picture doesn't zoom in enough...it looks like the composite body grinders (3102 & 3108), but that price seems to be about 1/2 what they would normally go for if bought separately.

I'm in want/need of an angle die grinder, but am having the usual dilemma of which model to spring for. There are a lot of 301 kits out there. Other than that, the 302A and 3102 are both about the same price. I'm just not sure that the 302A or 3102 are worth roughly double the price of the 301. The 302A doesn't seem to come packaged as a kit with any disks, whereas the 3102 is available with a kit or separate. If I don't get one of the kits...which size disks are the most useful (aka do these grinders bog down w/ a 3" disk)?

 

[Vinko]

I was surprised to note how cheap the IR guns were on Amazon. I looked up one that I had paid over $200 for from Grainger (admittedly a few years before) and it was going for less than $99 at Amazon.

 

[wrenchr]

CP is a very good tool.

 

[JayL]

The IR angle grinder set is out of stock again.

 

[Merkava_4]

Man I can't believe how low the price is on that IR die grinder kit. I paid close to $300 as I remember for my Sioux 1954HP way back in 1985 and that was for just one grinder!