Is the Mac E114401 the same as the Sunex 9935M

[Flinter987]

Is the Mac E114401 the same as the Sunex 9935M?
I got to looking at these two and they look mighty similar! Is Mac's a rebranded Sunex product? If we can figure anything out, I'll repost in the tool truck thread.
Thanks!
Fred

 

[WhiffySpark]

I don't see the similarity

 

[anndel]

They don't look similar at all. The set on the left is more angular at the bends and the set on the right is rounder.

 

[Tinner]

They're most likely Facom. grab a set on a Zoro sale for a great deal.

https://www.amazon.com/Stanley-Proto-Facom-FM-57-JE5-Obstruction/dp/B002FCLGV8

 

[Flinter987]

I think you are right Tinner. The Mac's are a good bit cheaper than the Facoms though.
http://www.mactools.com/en-us/Expert/Wrenches/E114401/5-PC-Metric-Half-Moon-Wrench-Set-12-PT-
And I get a student discount to boot!

 

[Flinter987]

Anybody know where sunex gets theirs? They are super cheap on Ebay right now. Do they source them direct from Taiwan or China?

 

[Tallpilot]

Pretty sure they are China which kept me from getting them. The Taiwan sockets are great, the Chicom wrenches not so much. I was looking at the angle wrenches since they match the Snap-on 30/60 that no one else does.

 

[kythri]

They're manufactured in China. My Sunex sets have CHINA stamped on the side opposite the Sunex logo.

I've only used 2 or 3 of them a handful of times, but they've seemed to be good quality.