JET 5” air angle grinder

[TonyJ]

Anyone have one or has used one and have anything good or bad to say about them ? Was getting ready to buy a IR one for $100 but was given this one from a fellow that recently retired from a welding and fabrication shop and no longer has a need for it. So for free I can’t complain and it’s quite and runs like new

 

[zkling]

Hope you have a big compressor, pneumatic angle grinders are very expensive to run when you are paying to compress the air. They like lots of air. Jet pneumatic tools are decent with a range of quality for price points. What is the coo? Japan?

 

[sberry]

Mine are not Jet but generic similar and very tough. I have 3, use them for cut off and wire wheel. They have ran hard and long and outlast premind units, never so much as had to tighten a screw on one.