Krl 722+756?

[crasher]

I've got a KRL 722 and 791 box combination now.
Rather than hang a side box on the 722, how hard would it be to bolt a KRL756 onto the side instead and make it a single unit?

I know it'd be easier to just roll them along side one another side-by-each, but I was looking to use the 756 as a workbench surface too, and I was thinking that it'd be a lot more stable/solid if it was anchored to the full 722 as well.

I don't feel like trading up to a 1023 at this point, so I was looking at this as a viable option.

Opinions, hints, tips, ideas welcome.

 

[Bellaireroad]

I've got a KRL 722 and 791 box combination now.

Rather than hang a side box on the 722, how hard would it be to bolt a KRL756 onto the side instead and make it a single unit?



I know it'd be easier to just roll them along side one another side-by-each, but I was looking to use the 756 as a workbench surface too, and I was thinking that it'd be a lot more stable/solid if it was anchored to the full 722 as well.



I don't feel like trading up to a 1023 at this point, so I was looking at this as a viable option.



Opinions, hints, tips, ideas welcome.

I have this setup, but with a second 722 I use as a work surface ....they are not bolted together ... they sit side by side it is plenty stable free standing ....you could drill holes in both boxes but there are no provisions for bolting them together. The handles come off but they tapped inside the box


Sent from my iPhone using Tapatalk