Large Angle Wrench Set Options

[WANNAFARM2]

Looking to purchase a set of SAE angle wrenches. Would like a full set up to at least 2 inch. Main use would be for hydraulic fittings and anything else that may come along. These would be occasional use, not everyday. Would like to stay under $300. I really like the new Tekton set, but they do not go very large. Any other options available? Not interested in paying up for snapon, etc. Just would like a full set, all the same brand.

 

[Carquest]

Check out V8 Tools, they make a set that I have sold that goes up to two inch. I think they were a bit over $300 if I remember correctly

 

[OHMS LAW]

I was lookin at the sunex set on amazon or the harbor frieght set.

 

[BukitCase]

List on the set Carquest referred to is $342, Amazon has it for $233 w/ free shipping

https://www.amazon.com/dp/B000K1LLHK/?tag=atomicindus08-20

I have a couple of their sets, the thin and the linked one - work well for hydraulics as mentioned... Steve

 

[plinker]

I have a 1-1/2 & 2" Sunex, worked just fine for the Hydraulic lines I used to work on.

 

[Zewnten]

Almost everyone where I work has the sunnex brand angle wrenches but I find that above 1 1/2 I'm better off with a crowsfoot to break the fitting free and a service wrench to turn it.

 

[Dave.R]

Looking to purchase a set of SAE angle wrenches. Would like a full set up to at least 2 inch. Main use would be for hydraulic fittings and anything else that may come along. These would be occasional use, not everyday. Would like to stay under $300. I really like the new Tekton set, but they do not go very large. Any other options available? Not interested in paying up for snapon, etc. Just would like a full set, all the same brand.

We are hoping to have the large patterns within the next year.

Dave

[email protected]

 

[Wamsutta]

Not interested in paying up for snapon, etc.

That's like putting a sign on your front door that says "No Soliciting."

 

[WANNAFARM2]

We are hoping to have the large patterns within the next year.

Dave

How big will the large patterns go? Would definitely be interested in waiting if I could get a full set of Tektons up to 2 inches.

 

[bob15]

Any other options available? Not interested in paying up for snapon, etc.

You might want to pay attention to the Snap On open end angles and buy either theirs or someone else who sets their wrench opening to 30/60°.

Watch the video to understand what I'm referring to:

And no, the display isn't a gimmick, as i remember trying my wrenches on it and it did exactly what the video shows. Needless to say, I bought the snappy set.