Lathe wiring help

[Musky_Hunter]

I have a Jet GHB-1440 lathe with the forward and reverse lever on the apron. It runs in forward in both positions. Someone has messed with the wiring on the back of the motor I think. The motor has 6 leads coming out of it. 3 of them are tied together with a wire nut. The other 3 are connected to a box in the back of the lathe. I have the wiring diagram but I am not smart enough to read it. Anyone have this lathe that could help me out with wiring?

 

[txvwnut]

Post a pic of the wiring diagram and a pic of the junction box and the motor.

 

[Musky_Hunter]

Here is the wiring diagram.



This is a bunch of **** I don't really understand.



This is the cover for the box where the motor connections are made.



These they cut off from the wires that went into the box on the motor.



These are 3 of the 6 motor wires twisted together