Locking socket adapters.

[FOCUS.FREAK]

If somebody could please guide me in the right direction. I'm looking for a set of 1/4,3/8, and 1/2 locking socket adapters. Not extensions but the adapters for the hex impact driver. I have the regular ones but you get to a point where the sockets just fall off occasionally. I saw that titan makes some on amazon but theirs only had 2 stars. I'd rather be safe than sorry I spent ***.** amount on a tool that doesn't work properly. If anyone has a link or anything it would help out a lot.


Ps. I did use the search function and only found 4 threads pertaining to locking ones. Here is an image of what I'm looking for...

Jordan

-Jordan

 

[92integra]

I used the titan ones for a good while and they are good just have to break them in..... The only others I know of is a snap on 1\4" set..... Part Number is 103tmlpa..... I have been using these for a week now I just picked them up and they are badass!

 

[Darius6t9]

I had bought the Titan set like what is pictured A few years ago. The 3/8 snapped within a week. The 1/4 doesn't hold the socket anymore and is very loose now. I don't use them anymore. The adapters are cheap enough that I just replace it when it gets worn out after a couple of years. Those Titans on the other hand wore out or broke in less than 6 months. I was sorely disappointed. I was hoping they would have been better quality. Your mileage may vary.

 

[warweapon762]

im using the titan ones with a pneumatic impact driver and they've held up fine for over a year.

 

[Ruger_556]

I think SK has some...

 

[pi_guy]

I used the titan ones for a good while and they are good just have to break them in..... The only others I know of is a snap on 1\4" set..... Part Number is 103tmlpa..... I have been using these for a week now I just picked them up and they are badass!

I use the snap -on ones also. I do not think that 1/4 inch gun is designed to spin 1/2 drive sockets, and I would suspect that large 3/8 sockets would create the same issue.

 

[Bobioz1]

I use the short locking one out of that snap on set with locking impact extensions all day long. Had it warrantied once in about 4 years. Have a 3/8 matco locking that see's less use and has held up fine. Had some of those cheaper ones before. Impact use twisted them in two.

 

[T45]

You can also a set get pin locking versions in 3/8 (and 1/2 I believe).

http://buy1.snapon.com/catalog/item.asp?item_ID=648134&group_ID=681630

Note these are not QR but they will lock onto a larger socket if needed.