Willh
Member
Looking to finish my walls off with magnesiacore and would like some feedback from others that have done the same. A few words here and there but no designated thread... Stuff is expensive, was it worth it would you do it again?
Walls are 16 on center, trusses 24. The 9mm board should span the 24 without sagging and without the need of furring strips or am I asking too much of the material?
Did those of you that have done it have boards ending on studs like gyproc or in between with pieces nailed in back for support?, both horizontal and vertical? If so how much more beyond the actual square footage of the area to be covered did you need?
Looking for fireproof walls/ceiling, what did you do to the joints, leave a gap and fill with x filler or but them together with a little epoxy to seal the deal?
This would appear to be the ideal material for garage. Lets here it. Better yet let's see it.
Thanks,
Will
Walls are 16 on center, trusses 24. The 9mm board should span the 24 without sagging and without the need of furring strips or am I asking too much of the material?
Did those of you that have done it have boards ending on studs like gyproc or in between with pieces nailed in back for support?, both horizontal and vertical? If so how much more beyond the actual square footage of the area to be covered did you need?
Looking for fireproof walls/ceiling, what did you do to the joints, leave a gap and fill with x filler or but them together with a little epoxy to seal the deal?
This would appear to be the ideal material for garage. Lets here it. Better yet let's see it.
Thanks,
Will
