Magnetic Nut Drivers?

[JDon99]

I will be doing some dash work on my truck and will be nice to have some magnetic nut drivers, are there any quality brands that sell them? I've seen some cheapies out there, but would prefer quality stuff. Otherwise I may just break out the masking tape and regular drivers.

 

[jcfields]

.

 

[txdude87]

+1 for Klein. Mine have lasted 5 years so far without a problem. They are nice and long as well.

 

[JDon99]

Gotta have Metric and SAE

 

[Brownsfan]

I have looked and NEED a set in metric mainly. I do most of the.work I do in the interior and dash area. Klein only does SAE. Snap.on is.not magnetic. I bought the snap on tmr4 ratcheting 1/4 dr socket holder and the 7mm 8mm an 10mm because they are the.most used in the dashboard. I am getting a 5.5mm next week. They.are expensive. Until i find a metric magnetic set

 

[T45]

For magnetic, these look nice

Felo 400 Series Ergonic M-Tec Professional Magnetic Nut Drivers #42810636

http://www.discounttrader.com.au/fe...c-professional-magnetic-nut-drivers-42810636/

 

[defektes]

For the magnetics, I use the changeable bit Craftsman 1/4 bit driver that came with almost all the tool sets back in the day. Usually the set will come with a group of metric and standard magnetic bits.

I use this to supplement my standard hollow shaft drivers... it should still be made here in the States and readily available.


EDIT:

It does not come with magnetic bits, I purchased some 1/4 magnetic nut drivers to use...mine are Wiha, German made and readily available on Amazon or industrial supply houses.