Manual Iron Worker

[Zephyr20]

Does anyone recognize this Iron Worker?
I have done a little searching online and have not found any information.
Other than “Alloy”, there doesn’t seem to be any other words or letters that would indicate a brand name.
Has a cutter, a punch, and a bender/brake.
Any information anyone might have would be greatly appreciated!

Thank you!

 

[nickwarchol]

Does anyone recognize this Iron Worker?
I have done a little searching online and have not found any information.
Other than “Alloy”, there doesn’t seem to be any other words or letters that would indicate a brand name.
Has a cutter, a punch, and a bender/brake.
Any information anyone might have would be greatly appreciated!

Thank you!

I actually have one just like that and have not been able to find out any information. I picked it up at an auction when a local school was closing up an industrial arts department. Other than cutting some 1/8" x 1" flat stock and 1/4' rod I haven't used it for much.

 

[Zephyr20]

Hey Nick,
Thanks for the response!
It is really wierd that there is no info on this iron worker. It must be a foreign made unit that didn't get much traction in the states.
I am most interested in using it as a punch, but I may not have much luck in finding dies for it.
I bought it from a guy locally for $80, and he said he bought it 20 years ago and didn't use it much.

Rick