Matco Angled Plier Set (Knipex)

[havinnoj]

Anybody use these angled head Matco (Knipex) pliers? The 3pc set is the SPA3 and the needlenose I'm interested in is the PNC8E. Looking for any feedback or the Knipex needlenose p/n. Thanks

 

[wafrederick]

I have the set and saved me time on a few job.Here is a video on you tube on all three pliers this way

 

[Monte]

they´re made by Orbis-Will. A subsidiary of Knipex.
http://www.orbiswill.de
http://orbiswill.de/uploads/media/Evol_ne_Produkt_Info_05.pdf

 

[havinnoj]

I have the set and saved me time on a few job.Here is a video on you tube on all three pliers this way

Thanks for the video. How do you like the set? How about the angled heads versus straight heads?

they´re made by Orbis-Will. A subsidiary of Knipex.
http://www.orbiswill.de
http://orbiswill.de/uploads/media/Evol_ne_Produkt_Info_05.pdf

Thanks Monte!

 

[wafrederick]

The angled heads get in the tight spots very well.One spot was in a Kia Rio,I had to get a hold of the tab on a holder holding the wiring harness in place and the angled needle nose fit in the spot