Bennie
Well-known member
I purchased a lift last week through the group buy setup by UPSHIFT (thanks UPSHIFT!).
It was delivered yesterday so my next step is figuring out placement and installing it.
I have in-floor heat in the garage. Does anybody have any good tips on figuring out where the tubing is run? I have limited pictures of the tubing before the concrete was poured and of course I was not planning on putting a lift in there so there was no preparation for one.
I was planning on getting the system running and using an infrared temp gun to as it warms up to figure out roughly where it's run. Between that and the pictures I though I may be able to figure it out.
This is not something i'd like be be pretty sure on, I want to be positive. Until I do this (warm up with temp gun) I won't have any idea how well, if at all, it works.
Are there any businesses that can come out and figure this out?
Thanks for any advice!
It was delivered yesterday so my next step is figuring out placement and installing it.
I have in-floor heat in the garage. Does anybody have any good tips on figuring out where the tubing is run? I have limited pictures of the tubing before the concrete was poured and of course I was not planning on putting a lift in there so there was no preparation for one.
I was planning on getting the system running and using an infrared temp gun to as it warms up to figure out roughly where it's run. Between that and the pictures I though I may be able to figure it out.
This is not something i'd like be be pretty sure on, I want to be positive. Until I do this (warm up with temp gun) I won't have any idea how well, if at all, it works.
Are there any businesses that can come out and figure this out?
Thanks for any advice!