MaxJax missing part - Nevermind, I found it.

[anaxagoras]

I appear to be missing the "Long 90-Degree 3/8” x 3/8” O-Ring Fitting" it's the right angle pipe that screws into the side of the pumping unit that then connects to a short hose that then goes to the flow divider. see page 9 fig 3.5 http://www.maxjaxusa.com/downloads/MaxJax-Manual.pdf

Is this a standard part that I can get at a hardware store? Is that the proper name for it? I don't want to wait until Monday to call the distributor and then a few days on top of that for the part.

 

[Junkman]

Re: MaxJax missing part - "Long 90-Degree 3/8” x 3/8” O-Ring Fitting"

I don't believe that you will find it at a hardware store, but it can be had by going to a place that makes up hydraulic hoses. Check your local yellow pages for hydraulics. You also might find it at an auto parts store that carries hydraulic fittings. It is a standard part, but it isn't sold everywhere. I live in CT on the MA/RI line, and if you can't find it, I will give you the one off my lift if that will help you out.

 

[anaxagoras]

Re: MaxJax missing part - "Long 90-Degree 3/8” x 3/8” O-Ring Fitting"

Thanks for the reply, but it turns out i'm a retard, the part fell out of the bag and was in the bottom "fold" of the box.

 

[Junkman]

If you need any help putting it together, let me know. I think that it took me all of about 45 minutes to uncrate and fully assemble. Junk

 

[anaxagoras]

thanks for the offer, I've got all the hydraulic fittings attached, now just need to figure out where to place the thing / drill the holes. What part of CT are you from? I'm about 10 minutes outside of new haven.

 

[Junkman]

thanks for the offer, I've got all the hydraulic fittings attached, now just need to figure out where to place the thing / drill the holes. What part of CT are you from? I'm about 10 minutes outside of new haven.

outside of Putnam near the MA border